So what is a “Gap filler” patch? It's a patch small enough to fill those annoying little gaps between other patches on your jacket, or the awkward little spaces between seams where nothing else fits!
- 2.1” tall (5.5cm)
- Iron on
- Embroidered detail
- Heat cut edge
- Also available as an enamel pin HERE
- Bonus point: A percentage of profits go to our local animal sanctuary, see the ‘About Life Club’ page to find out more!
INSTRUCTIONS FOR APPLYING PATCH TO GARMENT
Step 1: Set your hand iron at the hottest temperature setting. Do not use ANY steam!
Step 2: Place your patch in the desired position and place a cloth such as a handkerchief, sheet, tea towel or pillowcase over the top.
Step 3: Press the iron straight down for 35-45 seconds with as much constant pressure as possible. No back and forth movements but you can use slow circular movements.
Step 4: Turn the garment inside-out and repeat steps 2 & 3.
Step 5: Allow the patch to cool down.
Step 6: (optional) Now the patch is attached, you can add a couple of stitches to the corners for extra-safe secureness! Alternatively, if you are a sewing whizz you can just sew the patch into place and then there is no need for ironing at all!